30th of april 2015 saw the publication of a revised standard relating to firefighting lifts, en 81-72: 2015, which replaced en 81-72:2003. the standard applies to the exclusive use of a passenger (or passenger/goods lift) by the fire service to carry firefighters and their equipment to the required floors, in the event of a fire.
the number of firefighting lifts, and their location within the building, are determined by national regulations and are an important tool for fire attack, transporting firefighters and equipment and for evacuation under the control of the firefighters. note – as the water from fire hoses is of high volume and pressure, it may be appropriate to install pumps/drainage measures even when the measures to minimise ingress of water have been taken.
with increasing building height , fire fighting lifts are becoming more prevalent in building design and to cater for this i have reviewed the building standard en 81-72 for fire fighting lifts.. the standard applies to the exclusive use of a passenger (or passenger/goods lift) by the fire service to carry firefighters and their equipment to the required floors, in the event of a fire. a firefighting lift, unlike a normal lift, should be designed to operate for as long as is practicable when there is a fire in the building.
in addition for this the minimum interior dimensions are 1100 mm wide by 2100 mm deep â· additional lift control system features are required above that which would be incorporated on a nonâfirefighting lift where measures such as those above are not taken to prevent the ingress of water into the lift shaft, then measures are taken to prevent water build up in the pit e.g. the pumps are fitted outside of the lift shaft, and provided with a secondary power supply note â as the water from fire hoses is of high volume and pressure, it may be appropriate to install pumps/drainage measures even when the measures to minimize ingress of water have been taken.
a simple guide to the requirements for firefighting lifts the minimum rated load of the lift is 630kg the minimum interior lift car dimensions does anyone have knowledge of specifying a kw rating or flow rate for a fire fighting lift, sump pump ? i have checked various documents but with increasing building height , fire fighting lifts are becoming if a sump pump is used, it is located outside of the lift shaft and, fire fighting lift requirements, fire fighting lift requirements, en81-72 fire fighting lifts, fire fighting lift building regulations, kone fire fighting lift.
are put in place to check that firefighting lifts are correctly maintained and available for use when required; if a sump pump is used, in elevators provided with firefighters’ emergency operation, a drain or sump pump shall be provided. the sump pump/drain shall have the fireman’s lift requirements under en81-72 and bs en81-72 firefighter 3- way elevator intercom system do en81-72’s elevator requirements apply, fire fighting lift maintenance requirements, fire fighting lift size, fire fighting lift building height, fire fighting lift british standard, fire fighting lift signage, evacuation lift, fire lift in a high-rise building, fire fighting lift power supplies.
When you try to get related information on fire fighting lift sump pump, you may look for related areas. fire fighting lift requirements, en81-72 fire fighting lifts, fire fighting lift building regulations, kone fire fighting lift, fire fighting lift maintenance requirements, fire fighting lift size, fire fighting lift building height, fire fighting lift british standard, fire fighting lift signage, evacuation lift, fire lift in a high-rise building, fire fighting lift power supplies.